Simple, inexpensive, EZ to build Flying Crank

While working on my Ultralignt FCG I got to thinking that with a little thought I could build a flying crank using very basic hand tools and a simple designee from inexpensive, easily available parts. I couldn't resist the challenge and I'm quite pleased with the results.

Since this was something of a pilgrimage into the unknown I felt I should incorporate most of the mystical elements required for a successful DIY project including duck tape, glue, coat hanger, hammer and sticks.

All of the parts are from Home Depot and the swap meet. None of the dimensions are very important. None of the parts are "special" so feel free to improvise (that's what I did). No special tools are required (I used tools I thought most people would have, could borrow or could buy for very little money)

Finished product hanging in the FCG room. 

PDQ_FCG_132.JPG (51352 bytes)

 Most of the parts.

pdq_fcg4.JPG (58067 bytes)

                                          

 Building the frame work

PDQ_FCG_60.JPG (62260 bytes)

 Connecting crank to rotisserie motor

pdq_fcg36.JPG (49294 bytes)

 Attaching motor to frame work

PDQ_FCG_101.JPG (65503 bytes)
The washer at the end of the crank

PDQ_FCG_130.JPG (42606 bytes)

 Washer, crank and motor integration

PDQ_FCG_119.JPG (57451 bytes)

    Sky hooks - bolting it up to the ceiling

PDQ_FCG_109.JPG (55592 bytes)

       

 The finished product

PDQ_FCG_110.JPG (50347 bytes)

  

Last updated on 09/30/2003